Condrive retailer 1000 Multi-Purpose Tool for Installing Tapcon Hex Head & Phillips Flat Head Anchors

Fast change from drilling to drivingEliminates need to change out chuck and bitsEliminates need for two toolsSpecial nut driver is recessed for torque control to reduce head breakageIncludes bits for all sizes hex and phillips headFor use with anchors up to 3-3/4" longCondrive® 1000 – A multi-purpose tool designed for installation of Tapcon hex head and Phillips flat head anchors up to 3-3/4″ long. If driving hex washer head Tapcon, driver will automatically disengage. The 1000 has a reusable plastic case. *Note: for anchors 4″ long and above, drill the hole with just the bit, then remove the bit and install with the Condrive 1000. Buildex Condrive Tools retailer are designed to specifically install Tapcon Anchors and to fit standard Chuck or SDS Plus Style hammer drills.Kit Includes:Item No. Description of Parts for Condrive 1000 Part No.1 #2 Phillips Bit for 3/16″ Dia Tapcon 31109102 #3 Phillips Bit for 1/4″ Dia Tapcon 31119103 1/4″ Socket for 3/16″ Dia Tapcon 31089104 1/8″ Ball Bearing 31219105 1/8″ Hex Key 31229106 5/16″ Socket for 1/4″ Dia Tapcon 31099107 5/32″ Ball Bearing 31079108 Black Band 31069109 Drill Adapter 310491010 Phillips Socket 311291011 Set Screw (2) 312091012 Sleeve 3105910Specifications:CONDRIVE 1000 GUIDELINES:STEP 1: Place correct drill bit into driver adapter and drill hole 1/4″ deeper than depth of embedment.STEP 2: Slide Condrive Installation Tool sleeve over drill bit. Snap hex head or Phillips Socket in place.STEP 3: Insert anchor in socket, position fixture to be fastened, begin to drive Tapcon into pre-drilled hole.STEP 4: The anchor is fully set when the nosepiece of the Condrive Tool automatically disengages from thesocket and fixture is secured in place.