Acrylic Soap Cutter Adjustable Log Splitter Soaps Making Supplies retailer

Acrylic Soap Cutter Adjustable Log Splitter Soaps Making Supplies

Size : As the picture shows


Usage Guidelines

The acrylic soap dispenser has been installed at the time of shipment and buyers can use it directly.

To change the wire posiition, turn the wire adjustment knob to loosen the wire, then adjust the size adjusters on both sides to the desired position. Because the adjusters are attached to the acrylic plate for a long time, they may stick to the acrylic plate and cannot be adjusted. At this time, you need to peel off the adjuster from the acrylic base. . Tighten the steel wire after adjusting to a suitable position.
Note: This soap cutter is designed for cutting pre-cured soap, not hard cured soap.


Wire replacement method:

This step requires tools such as pliers and scissors, and please wear gloves and safety glasses to avoid injury.
1. Cut a piece of steel wire approximately 60 cm (23 inches) in length.

2. Put one end of the wire on the screw on one side of the size adjuster, pass the other end of the wire through the adjuster hole, and then pass retailer through the metal wire hole on the other side, and then tie it to the knob adjuster.

3. Turn the knob to tighten the steel wire.