Cuff bracelet for men Custom Fit Cross Peen Hammered cuff bracelet, retailer blacksmithed, hand made, anvil forged, Gift for Him, Men's bracelet

Your cuff bracelet will be custom made for you and you only. I don't back stock anything.

I'll start with 1/4" stainless square stock, heat it in the coal forge to yellow, and then hammer it on the anvil diagonally with a wedge-like peen until it's about 3/8 of an inch wide. This will take several heats (a "heat" is one trip into the forge to get it glowing hot). For the last heat I'll quench it in water to darken it. I'll hand sand it so that the low spots stay darker gray and the higher ridges will be lighter. I'll then finish shaping and sizing it while it's cold.

SIZING: Measure your wrist at the cuff, between your hand and that little knobby wrist bone. Let me know the exact measurement, and I'll adjust it to fit comfortably - not too tight, not too loose. retailer

I can usually get it shipped within a week.

Convo with any questions or special requests.