Shot Plate #3 "Tetrahedron ", silversmith, goldsmith, metal clay retailer

Plate Measurements: 2in X 1 7/8in X 1/2in
Pusher: 3/8in X 3 in (Soft tool steel)
Shots : 5.5 mm to 8.5 mm (ish)
Block: A2 tool steel, hardened & tempered
*Silver shot not included *

It will take 2 to 3 rounds of annealing & hammering to achieve this kinda relief..

*These New blocks are tempered & can be used in a hydraulic press or by hand**

*****excess force produce by a hydraulic may cause the shot to stick, use at retailer your own risk*****

Pusher: 3/8in X 3 in (Soft tool steel) SOLD SEPARATELY
-Additional Pusher sizes: https://www.etsy.com/sg-en/listing/805789537/steel-pusher-for-shot-plate
-Chisel for removing shot: https://www.etsy.com/listing/1303567927/chisel-for-shotimpression-plate

All Shot Plates proudly made in my NM Studio..

YouTube video on making uniforn shot.. https://youtu.be/0ls86Rt_t3k